Glass Breakage Sensor Check Procedure

When the Scion Security was installed in your vehicle, care was taken to adjust the sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works following the procedure listed below.

ARM the system.
Press the lock button on the remote control or lock the doors with the key.

(Remember, the system will not ARM if any door, the trunk or hatch is open.)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Wait until the STATUS MONITOR'S LED starts flashing. The LED will flash 30 seconds after the last door, the trunk or hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds .

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
With the tip of a key, tap the center of the driver's door window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.

A WARN AWAY ALARM should be TRIGGERED. If the ALARM is not TRIGGERED, make sure you performed the procedure correctly and try again. If you find that the system did not perform as expected, contact your Scion dealer for more information.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002