LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2010 >> xD Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Meter (Diagnostics - Introduction) >> Meter / Gauge System >> Fail-Safe Chart >> Fail-Safe Chart

Fail-Safe Chart

SPEEDOMETER

Condition Response Recovery
Malfunction in vehicle speed signal (SI, SP1). Needle does not move. Normal data is received.
TACHOMETER

Condition Response Recovery
Malfunction in engine rpm signal (NE1). Needle does not move. Normal data is received.
FUEL GAUGE

Condition Response Recovery
Vehicle speed signal (SP1) not input. Controlled as input signal of "0 km/h". Normal data is received.
Starter signal (ST) not input for 3.1 sec or more. Controlled as starter signal off. Normal data is received.
SHIFT INDICATOR

Condition Response Recovery
No input of shift position signal. Shift display not illuminated. Normal data is received.
BRAKE

Condition Response Recovery
Brake warning light signal not input for 1 sec. or more at 9.5 V or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
Parking brake switch signal not input for 10 sec. or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
ABS

Condition Response Recovery
ABS warning light signal not input for 1 sec. or more at 9.5 V or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
OIL PRESSURE

Condition Response Recovery
Oil pressure switch signal input. Remains illuminated until ignition switch is off. Normal data is received.
CHECK E/G

Condition Response Recovery
Check engine warning signal input. Remains illuminated until ignition switch is off. Normal data is received.
DRIVER SIDE SEAT BELT

Condition Response Recovery
Driver seat buckle switch signal not input for 10 sec. or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
AIRBAG

Condition Response Recovery
Center airbag sensor signal not input for 10 sec. or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
COOL, HOT

Condition Response Recovery
Engine coolant temperature signal not input for 3.1 sec. or more while ignition switch is ON. HOT indicator remains off until ignition switch is off.
COOL indicator blinks until ignition switch is off.
Normal data is received.
CHARGE

Condition Response Recovery
Charge light indicator signal not input while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
DOOR

Condition Response Recovery
Courtesy switch signal not input for 10 sec. or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
EPS

Condition Response Recovery
EPS warning light signal not input for 1 sec. or more at 9.5 V or more while ignition switch is ON. Remains illuminated until ignition switch is off. Normal data is received.
VSC OFF

Condition Response Recovery
VSC warning light signal not input. Remains illuminated until ignition switch is off. Normal data is received.
SLIP

Condition Response Recovery
Slip indicator signal not input. Remains illuminated until ignition switch is off. Normal data is received.
TIRE PRESSURE

Condition Response Recovery
Tire pressure warning signals are interrupted while ignition switch ON. Tire pressure warning light blinks for 60 seconds while ignition switch ON. Normal data is received.
Remains illuminated until ignition switch is off.
WASHER

Condition Response Recovery
Washer level warning signal input. Remains illuminated until ignition switch is off. Normal data is received.
MAINT REQD

Condition Response Recovery
ODO value not displayed when reset is performed. ODO display is "0". Normal data is received.
MAINT REQD light illuminates.
CRUISE

Condition Response Recovery
Cruise active signal not input. Remains illuminated until ignition switch is off. Normal data is received.
TRAC OFF

Condition Response Recovery
TRAC OFF indicator signal input. Remains illuminated until ignition switch is off. Normal data is received.