Inspection Procedure

1. Perform torque sensor zero point calibration (See CALIBRATION  ).

1. Check for DTCs.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC still output even after performing torque sensor zero point calibration.	A
   Normal system code output.	B

B : END 

A: Go to Next Step 

1. Perform torque sensor zero point calibration again (See CALIBRATION  ).

1. Check for DTCs.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC still output even after performing torque sensor zero point calibration twice.	A
   Normal system code output.	B

B : END 

A: Go to Next Step 

1. Perform torque sensor zero point calibration again (See CALIBRATION  ).

1. Check for DTCs.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC still output even after performing torque sensor zero point calibration 3 times.	A
   Normal system code output.	B

   HINT:

   The steering column assembly must be replaced if C1515/15 is still output even after the torque sensor zero point calibration is performed 3 times.

B : END 

A : REPLACE STEERING COLUMN ASSEMBLY  (See REMOVAL )