On-Vehicle Inspection

REMOVE FRONT WHEEL
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY (See REMOVAL )
REMOVE FRONT DISC
INSPECT FRONT AXLE HUB BEARING
1. Inspect the axle hub backlash.
  1. Using a dial indicator, check the backlash near the center of the axle hub.
    Maximum:
    
    0.05 mm (0.0020 in.)
    
    If the backlash exceeds the maximum, replace the bearing.
    
    Fig 1: Checking Axle Hub Backlash
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Inspect the axle hub runout.
  1. Using a dial indicator, check the runout of the surface of the axle hub.
    Maximum:
    
    0.05 mm (0.0020 in.)
    
    If the runout exceeds the maximum, replace the bearing and axle hub.
    
    Fig 2: Checking Axle Hub Runout
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DISC
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)