LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xD Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock >> Wireless Door Lock Control System >> Data List / Active Test

Data List / Active Test

  1. READ DATA LIST 

    HINT:

    Using a Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time

    NOTE: In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body Electrical / Main Body / Data List.
    5. According to the display on tester, read on the "Data List".

      Main Body: 

      DATA LIST - MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF ON Driver side door is open
      OFF Driver side door is closed      		 -
      P Door Courtesy SW Passenger side door courtesy light switch signal / ON or OFF ON Passenger side door is open
      OFF Passenger side door is closed      		 -
      RR Door Courtesy SW Rear door RH courtesy light switch signal / ON or OFF ON Rear door RH is open
      OFF Rear door RH is closed      		 -
      RL Door Courtesy SW Rear door LH courtesy light switch signal / ON or OFF ON Rear door LH is open
      OFF Rear door LH is closed      		 -
      Back Door Courtesy SW Back door courtesy switch signal / ON or OFF ON Back door is open
      OFF Back door is closed      		 -
      Key Unlock Warning SW Unlock warning switch / ON or OFF ON Ignition key is inserted
      OFF Ignition key is not inserted      		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body Electrical / Main Body / Active Test.
    5. According to the display on tester, perform the "Active Test".

      Main Body 

      ACTIVE TEST DETAIL - MAIN BODY

      Tester Display Test Part Control Range Diagnostic Note
      Hazard Turns FLSH relay ON / OFF ON or OFF -
      Vehicle Horn Sounds vehicle horn ON / OFF ON or OFF -
      Wireless Buzzer Wireless door lock buzzer ON/ OFF ON or OFF -
scientia non olet · About LEMON Manuals