Front Door Lock: Removal
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the RH side.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE FRONT ARMREST BASE UPPER PANEL (See DISASSEMBLY )
- REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See DISASSEMBLY )
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL (See DISASSEMBLY )
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (See REMOVAL )
- REMOVE FRONT DOOR BELT MOLDING ASSEMBLY (See REMOVAL )
- REMOVE FRONT DOOR TRIM BRACKET (See DISASSEMBLY )
- REMOVE FRONT DOOR SERVICE HOLE COVER (See DISASSEMBLY )
- REMOVE FRONT DOOR GLASS SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE FRONT DOOR GLASS RUN (See DISASSEMBLY )
- REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY (See DISASSEMBLY )
- REMOVE FRONT DOOR OUTSIDE HANDLE COVER (See DISASSEMBLY )
- REMOVE FRONT DOOR LOCK
- Disconnect the connector.
- Using a "TORX" socket wrench T30, remove the 3 screws.
- Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and cables as a unit.
- Remove the front door lock open rod from the front door lock.
- Remove the door lock wire harness seal from the front door lock.
- Remove the front door lock remote control cable.
- Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
- Remove the front door inside locking cable.