Personal Light Assembly: Inspection

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT PERSONAL LIGHT ASSEMBLY

Check the resistance.

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Switch Condition	Specified Condition
1-2	OFF	10 kΩ or higher
1-2	Drivers switch ON	Below 1 Ω
1-2	Passengers switch ON	Below 1 Ω

If the result is not as specified, replace the personal light.

Check the light operation.
1. Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 2, then check that the light illuminates.
  OK: Light illuminates.
  
  If the light does not illuminate, replace the bulb.
  
  Fig 1: Identifying Personal Light Connector Terminals
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002