Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR SST 09224-00010
1. Using SST, install the heated oxygen sensor.
  Torque:
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  Torque:
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  NOTE:
  - This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and a SST with 30 mm (1.18 in.) (See REPAIR INSTRUCTION ).
  - This torque value is effective when SST is parallel to the torque wrench.
    
    Fig 1: Identifying Heated Oxygen Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the heated oxygen sensor connector.
INSPECT FOR EXHAUST GAS LEAK

Fig 2: Locating Heated Oxygen Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002