Inspection Procedure

HINT:

• If any of DTCs P0115, P0117, P0118 or P0125 are set simultaneously with DTC P0116, the ECT sensor may have an open or a short circuit. Troubleshoot those DTCs first.
• Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream ON.
   4. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
   5. Read DTCs.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      P0116	A
      P0116 and other DTCs	B

   B: Go TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART )

   A: Go to next step 

2. INSPECT THERMOSTAT 
   1. Remove the thermostat (See REMOVAL ).
   2. Measure the valve opening temperature of the thermostat.

      Standard value: 

      80 to 84°C (176 to 183°F) 

      HINT:

      In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

   3. Reinstall the thermostat (See INSTALLATION ).

   NG : REPLACE THERMOSTAT  (See REMOVAL )

   OK : REPLACE ENGINE COOLANT TEMPERATURE SENSOR  (See REMOVAL )