Diagnostic Trouble Code Chart: Notes
NOTE:
Turn the ignition switch to OFF before removing parts.
HINT:
- If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the information for the respective "DTC Code" in the DTC chart.
- When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
- Inspect the fuse and relay before investigating the trouble areas as shown in the table below.
DTC chart of ABS:
DTC CHART OF ABS
| DTC Code | Detection Item | Trouble Area |
|---|---|---|
| C0200/31 (*1) | Front Speed Sensor RH Circuit |
|
| C0205/32 (*1) | Front Speed Sensor LH Circuit |
|
| C0210/33 (*1) | Rear Speed Sensor RH Circuit |
|
| C0215/34 (*1) | Rear Speed Sensor LH Circuit |
|
| C0226/21 | SFR Solenoid Circuit |
|
| C0236/22 | SFL Solenoid Circuit |
|
| C0246/23 | SRR Solenoid Circuit |
|
| C0256/24 | SRL Solenoid Circuit |
|
| C0273/13 (*1) | Open in ABS Motor Relay Circuit |
|
| C0274/14 | Short to B+ in ABS Motor Relay Circuit |
|
| C0278/11 | Open in ABS Solenoid Relay Circuit |
|
| C0279/12 | Short to B+ in ABS Solenoid Relay Circuit |
|
| C1225/25 | SM Solenoid Circuit |
|
| C1235/35 | Foreign Object is Attached on Tip of Front Speed Sensor RH |
|
| C1236/36 | Foreign Object is Attached on Tip of Front Speed Sensor LH |
|
| C1238/38 | Foreign Object is Attached on Tip of Rear Speed Sensor RH |
|
| C1239/39 | Foreign Object is Attached on Tip of Rear Speed Sensor LH |
|
| C1241/41 | Low Battery Positive Voltage or Abnormally High Battery Positive Voltage |
|
| C1243/43 (*1) | Acceleration Sensor Stuck Malfunction |
|
| C1244/44 | Open or Short in Acceleration Sensor Circuit |
|
| C1245/45 (*1) | Acceleration Sensor Output Malfunction |
|
| C1246/46 (*2) | Master Cylinder Pressure Sensor Malfunction |
|
| C1249/49 | Open in Stop Light Switch Circuit |
|
| C1251/51 (*1) | Open in Pump Motor Circuit |
|
| C1361/91 | Short Circuit in ABS Motor Fail Safe Relay Circuit |
|
| C1381/97 | Yaw Rate and / or Acceleration Sensor Power Supply Voltage Malfunction |
|
| U0073/94 | Control Module Communication Bus OFF | CAN communication system |
| U0124/95 | Lost Communication with Lateral Acceleration Sensor Module | CAN communication system (Skid control ECU to yaw rate and acceleration sensor) |
(*1,*2): Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
|
||
HINT:
In some cases, the intelligent tester or Techstream cannot be used when the ABS warning light remains on.