Valve Body Assembly: Installation

1. Align the groove on the manual valve with the pin of the lever.
2. Install the transmission valve body assembly with the 17 bolts.

   Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

   NOTE:

   • Push the valve body against the accumulator piston springs and check ball body to install the valve body.
   • First, temporarily tighten the bolts marked with (1) in the illustration because they are positioning bolts.

   Bolt length: 

   25 mm (0.984 in.) for Bolt A 

   41 mm (1.614 in.) for Bolt B 

   45 mm (1.771 in.) for Bolt C 

   Fig 1: Identifying Transmission Valve Body Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat the O-ring of the ATF temperature sensor with ATF.
2. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

3. Connect the 5 shift solenoid valve connectors.
   Fig 2: Identifying Bolt And Lock Plate

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring with ATF, and install it into the valve body oil strainer assembly.
   Fig 3: Locating O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the valve body oil strainer assembly with the 3 bolts.

   Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

   Fig 4: Locating Bolts And Valve Body Oil Strainer Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fluid type: 

Toyota Genuine ATF WS