LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Supplemental Restraint System) >> Rear Airbag Sensor >> Installation

Rear Airbag Sensor: Installation

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

HINT:

The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.

  1. INSTALL REAR AIRBAG SENSOR 
    1. Confirm that the ignition switch is turned to OFF.
    2. Confirm that the negative battery terminal is detached.
      CAUTION:
      • Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    3. Insert the hook into the body hole and install the airbag sensor with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      NOTE:
      • Do not use a rear airbag sensor that has been dropped.
      • Do not subject the rear airbag sensor to any impact or force.
    4. Confirm that there is no looseness by shaking the rear airbag sensor.
      Fig 1: Locating Rear Airbag Sensor Bolt
      G05390503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Connect the airbag connector.
    Fig 2: Identifying Airbag Connector
    G05390505Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY 
  4. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
  5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY  (See INSTALLATION )
  6. INSTALL REAR DECK TRIM COVER  (See INSTALLATION )
  7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  8. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  9. INSTALL REAR SEATBACK ASSEMBLY RH  (See INSTALLATION )
  10. INSTALL REAR SEATBACK ASSEMBLY LH  (See INSTALLATION )
  11. INSTALL REAR SEAT CUSHION WITH COVER PAD SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  13. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  14. INSTALL REAR DECK FLOOR BOX  (See INSTALLATION )
  15. INSTALL REAR FLOOR CARPET ASSEMBLY  (See INSTALLATION )
  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  17. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM  )

scientia non olet · About LEMON Manuals