LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Removal

Center Airbag Sensor Assembly: Removal

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See PRECAUTION  ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) 
  3. REMOVE INSTRUMENT CLUSTER FINISH CENTER LOWER PANEL  (See REMOVAL )
  4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT  (See REMOVAL )
  5. REMOVE FRONT NO. 1 CONSOLE BOX INSERT  (See REMOVAL )
  6. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL  (See REMOVAL )
  7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  9. REMOVE SHIFT LEVER ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  10. REMOVE SHIFT LEVER ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  11. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
    1. Pull the lever down and detach the connector holder.
      Fig 1: Locating Connector Holder
      G04830436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts and remove the airbag sensor.
scientia non olet · About LEMON Manuals