Crankshaft Position Sensor: Installation

1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
   Fig 1: Identifying O-Ring On Crankshaft Position Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the crankshaft position sensor with the bolt.

   Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf) 

   NOTE: Do not twist the O-ring.
3. Install the wire harness and crankshaft position sensor connector clamp.
4. Connect the crankshaft position sensor connector.
   Fig 2: Locating Crankshaft Position Sensor Connector And Crankshaft Position Sensor Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the generator assembly with the 2 bolts.

   Torque: Bolt A 

   21 N*m (215 kgf*cm, 16 ft.*lbf) 

   Bolt B 

   52 N*m (530 kgf*cm, 38 ft.*lbf) 

   Fig 3: Locating Generator Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the generator wire to terminal B with the nut.

   Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

3. Attach the clamp and connect the generator connector to the generator.
4. Install the 2 wire harness clamps.

Fig 4: Locating Wire Harness Nut & Clamps

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)