Typical Enabling Conditions
M/T Models, Case 1
M/T MODELS, CASE 1
| Monitor runs whenever following DTCs not present | None |
|---|---|
| Time after ignition switch OFF to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| ECT sensor circuit fail (P0115, P0117, P0118) | Not detected |
| MAF sensor circuit fail (P0102, P0103) | Not detected |
| Starter | OFF |
| Engine coolant temperature | 70°C (158°F) or more |
| Engine speed | 2000 to 5000 rpm |
| Engine load | 31.9% or more |
| Fuel-cut at high engine speed | Not executing |
M/T Models, Case 2
M/T MODELS, CASE 2
| Monitor runs whenever following DTCs not present | None |
|---|---|
| Time after ignition switch OFF to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Fuel-cut | ON |
A/T Models
A/T MODELS
| Monitor runs whenever following DTCs not present | None |
|---|---|
| Time after ignition switch OFF to ON | 3 seconds or more |
| Vehicle speed at output speed sensor | 13 km/h (8 mph) or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |