LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> xB Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs >> Rear Speed Sensor >> Installation

Rear Speed Sensor: Installation

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY  (See INSTALLATION )
  2. INSPECT REAR AXLE HUB BEARING LOOSENESS  (See ON-VEHICLE INSPECTION )
  3. INSPECT REAR AXLE HUB RUNOUT  (See ON-VEHICLE INSPECTION )
  4. CONNECT SPEED SENSOR WIRE 
    1. Connect the speed sensor wire connector to the speed sensor.
    Fig 1: Locating Skid Control Sensor Wire Connector
    G04832031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL REAR DISC  (See INSTALLATION )
  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY  (See INSTALLATION )
  7. INSTALL PARKING BRAKE CABLE ASSEMBLY  (See INSTALLATION )
  8. INSTALL REAR FLOOR SIDE MEMBER COVER  (See INSTALLATION )
  9. ADJUST PARKING BRAKE LEVER TRAVEL  (See ADJUSTMENT )
  10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  11. INSTALL REAR WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.lbf) 

  13. INSPECT REAR WHEEL ALIGNMENT 

    (See INSPECTION )

  14. CHECK VSC SENSOR SIGNAL 

    (See TEST MODE PROCEDURE  )

scientia non olet · About LEMON Manuals