Overload Reverse Operation

The sliding roof control ECU detects jams in the sliding roof operation, if they occur, from abnormal motor speed signals and reverses the sliding roof operation.

* When the battery terminal or fuse is disconnected, the roof position has to be reset to its initial position by the sliding roof control SW by following the procedure below:

1. Reconnect the battery terminal or fuse.
2. Turn ON the ignition switch.
3. Operate the sliding roof control SW to open the roof halfway or more.
4. Then operate the sliding roof control SW to fully close the roof.

   Do not release the switch for at least 2 seconds after the roof is fully closed.