Outer Rear View Mirror: Disassembly

CAUTION: If the mirror shatters during removal, flying debris may cause injuries. Be sure to wear protective clothing, gloves, glasses, etc. when performing these procedures.

NOTE: When replacing the mirror body, prevent damage to the mirror body by placing a protective cloth on the work area.

DISCONNECT MIRROR
1. Face the mirror holder upward and look at the bottom of the mirror. Find the 2 grooves between the mirror holder and holder base. Insert a screwdriver into a groove and twist it to release the claw. Then repeat for the other groove.
  HINT:
  
  Tape the screwdriver tip before use.
  
  CAUTION: To prevent the mirror from shattering and causing flying debris, apply tape to the front of the mirror.
  
  NOTE: To prevent damage to the vehicle, apply protective tape on the mirror holder base near the lower edge of the mirror. A piece of cloth can also be used.
  
  Fig 1: Disconnecting Mirror
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Lift up the lower part of the mirror holder and then release the 2 hooks on the top of the mirror.
3. Remove the mirror holder.
REMOVE MIRROR GARNISH
1. Detach the 7 claws.
2. Remove the garnish.
REMOVE SIDE TURN SIGNAL LIGHT LENS LH
1. Disconnect the connector.
2. Remove the 2 screws and lens.
  
  Fig 3: Locating Lens Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002