LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2009 >> tC Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Vane Pump >> Removal

Vane Pump: Removal

  1. REMOVE FRONT WHEEL RH 
  2. DRAIN POWER STEERING FLUID 
  3. REMOVE FRONT FENDER APRON SEAL RH  (See REMOVAL )
  4. REMOVE FAN AND GENERATOR V BELT  (See REMOVAL )
  5. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE 
    1. Remove the clip and disconnect the No. 1 oil reservoir to pump hose.
      NOTE: Take care not to spill fluid on the V belt.
      Fig 1: Identifying Pump Hose
      G05540534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DISCONNECT PRESSURE FEED TUBE ASSEMBLY 
    1. Remove the bolt and disconnect the pressure feed tube from the pump bracket rear.
    2. Using a 27 mm wrench to hold the pressure port union, remove the union bolt and gasket.
      Fig 2: Identifying Pressure Feed Tube Assembly
      G05540535Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE VANE PUMP ASSEMBLY 
    1. Disconnect the connector from the oil pressure switch.
    2. Using SST and a 14 mm deep socket, loosen the 2 bolts.

      SST 09249-63010 

    3. Remove the vane pump.
      Fig 3: Identifying Vane Pump Assembly
      G05540536Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals