Vane Pump: Installation

INSTALL VANE PUMP ASSEMBLY
1. Temporarily install the 2 bolts to the vane pump.
2. Install the vane pump with the 2 bolts.
3. Using SST and a 14 mm deep socket, fully tighten the bolts.
  SST 09249-63010
  
  Torque: 34 N*m (347 kgf*cm, 25 ft.*lbf)
  
  NOTE: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
  
  This torque valve is effective when SST is parallel to the torque wrench.
  
  Fig 1: Identifying Fulcrum Length
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the connector to the oil pressure switch.
CONNECT PRESSURE FEED TUBE ASSEMBLY
1. Install the pressure feed tube and a new gasket to the vane pump with the union bolt.
  HINT:
  
  Make sure the stopper of the pressure feed tube touches the vane pump body.
2. Using a 27 mm wrench to hold the pressure port union, torque the union bolt.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
3. Install the pressure feed tube with the bolt to the pump bracket rear.
  Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
  
  Fig 2: Identifying Pressure Feed Tube Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
1. Connect the No. 1 oil reservoir to pump hose with the clip.
  NOTE: Take care not to spill fluid on the V belt.
  
  Fig 3: Identifying Pump Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL FRONT FENDER APRON SEAL RH
INSTALL FRONT WHEEL RH (See INSTALLATION )
BLEED POWER STEERING FLUID
INSPECT FOR FLUID LEAK