Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
1. Using SST, install the sensor to the front exhaust pipe.
  SST 09224-00010
  
  Torque:
  
  40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
2. Connect the sensor connector.
  
  Fig 1: Identifying Heated Oxygen Sensor (For Bank 1 Sensor 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform the initialization (See INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK FOR EXHAUST GAS LEAKS