Inspection Procedure

1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC not output	A
   DTC output	B

B : INSPECT CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

A: Go to next step 

1. Connect the intelligent tester or Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test mode on the intelligent tester or Techstream (See DATA LIST / ACTIVE TEST  ).
   1. Intelligent tester

      ABS/VSC: 

      ABS/VSC REFERENCE
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      BUZZER	Skid control buzzer	Buzzer ON/OFF	Buzzer can be heard

   2. Techstream

      ABS/VSC/TRAC 

      ABS/VSC/TRAC REFERENCE
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      Buzzer	Skid control buzzer	Buzzer ON/OFF	Buzzer can be heard

4. Check that the buzzer sounds or stops in accordance with the intelligent tester or Techstream.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

   HINT:

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

B : REPLACE BRAKE ACTUATOR ASSEMBLY  (See REMOVAL  )

A: Go to next step 

1. Turn the ignition switch to OFF.
2. Replace the combination meter (See REMOVAL ).

1. Connect the intelligent tester or Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test mode on the intelligent tester or Techstream (See DATA LIST / ACTIVE TEST  ).
   1. Intelligent tester

      ABS/VSC: 

      ABS/VSC REFERENCE
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      BUZZER	Skid control buzzer	Buzzer ON/OFF	Buzzer can be heard

   2. Techstream

      ABS/VSC/TRAC 

      ABS/VSC/TRAC REFERENCE
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      Buzzer	Skid control buzzer	Buzzer ON/OFF	Buzzer can be heard

4. Check that the buzzer sounds or stops in accordance with the intelligent tester or Techstream.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

   HINT:

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

B : END 

A : REPLACE BRAKE ACTUATOR ASSEMBLY  (See REMOVAL  )