Transmission Wire: Installation

1. Coat a new O-ring with ATF and install it into the transmission wire.
   Fig 1: Locating O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the transmission wire through the transaxle case.
3. Install the transmission wire with the bolt.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   Fig 2: Locating Bolt And Transmission Wire

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Coat the O-ring on the ATF temperature sensor with ATF.
5. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

   Fig 3: Identifying Lock Plate

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the 5 shift solenoid valve connectors.

1. Install the 2 oil cleaner magnets onto the automatic transaxle oil pan sub-assembly, as shown in the illustration.
   Fig 4: Locating Oil Pan Magnets

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the automatic transaxle oil pan sub-assembly and a new oil pan gasket with the 18 bolts.

   Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

Fig 5: Locating Bolts And Automatic Transaxle Oil Pan Sub-Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fluid type: 

Toyota Genuine ATF WS