Shift Lever: Inspection

INSPECT SHIFT LOCK CONTROL ECU

Measure the voltage.

HINT:

Do not disconnect the shift lock control ECU connector.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION VOLTAGE CHART

Tester Connection	Switch Condition	Specified Condition
6 (ACC) - 1 (E)	Ignition switch ON	11 to 14 V
	Ignition switch ACC	11 to 14 V
	Ignition switch OFF	Below 1 V
4 (STP) - 1 (E)	Brake pedal depressed	11 to 14 V
4 (STP) - 1 (E)	Brake pedal released	Below 1 V
5 (KLS+) - 1 (E)	1. Ignition switch ACC and shift lever P position	7.5 to 11 V
	2. Ignition switch ACC and shift lever except P position	Below 1 V
	3. Ignition switch ACC and shift lever P position (After approx. 1 second)	6 to 9V
8 (IG) - 1 (E)	Ignition switch ON	11 to 14 V
8 (IG) - 1 (E)	Ignition switch OFF	Below 1 V

Fig 1: Inspecting Shift Lock Control ECU

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the shift lock control ECU.

Measure the resistance.

HINT:

Do not disconnect the shift lock control ECU connector.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION RESISTANCE CHART

Tester Connection	Condition	Specified Condition
1 (E) - Body ground	When battery voltage absent	Below 1 Ω

If the result is not as specified, replace the shift lock control ECU.

INSPECT TRANSMISSION CONTROL SWITCH

Measure the resistance between each terminal on the shift lock control unit assembly when the shift lever is moved to each position.

HINT:

Disconnect the transmission control switch connector.

Fig 2: Identifying Transmission Control Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Shift Lever Position	Specified Condition
6 (IG) - 13 (S)	S	Below 1 Ω
6 (IG) - 13 (S)	Except S	10 kΩ or higher
4 (SFTD) - 11 (E)	Continuously shift to "-" (Down-shift)	Below 1 Ω
4 (SFTD) - 11 (E)	S	10 kΩ. or higher
5 (SFTU) - 11 (E)	Continuously shift to "+" (Up-shift)	Below 1 Ω
5 (SFTU) - 11 (E)	S	10 kΩ or higher

If the resistance value is not as specified, replace the shift lock control unit.

INSPECT SHIFT LOCK SOLENOID

Measure the resistance.

HINT:

Disconnect the shift lock solenoid connector.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
3 (SLS-) - 4 (SLS+)	When battery voltage absent	112 Ω
1 (P) - 2 (E2)	Shift lever P position	10 kΩ or higher
1 (P) - 2 (E2)	Shift lever except P position	Below 1 Ω

Fig 3: Identifying Shift Lock Solenoid Connector Terminals

If the result is not as specified, replace the shift lock control unit.