Front Stabilizer Bar: Inspection

INSPECT FRONT STABILIZER LINK ASSEMBLY
1. Secure the stabilizer link LH with a vise.
2. Install the nut to the stud bolt.
3. Flip the ball joint back and forth 5 times or more.
4. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.
  Torque: Standard turning torque
  
  1.0 N*m (10 kgf*cm, 8.9 in.*lbf) or less
  
  Fig 1: Checking Ball Joint Stud Rotating Torque
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Check the dust boots for cracks or grease leakage. If the value is not within the specified range, replace the stabilizer link with a new one.