LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Spec, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning >> Blower Unit >> Installation

Blower Unit: Installation

  1. INSTALL BLOWER ASSEMBLY 
    1. Install the blower assembly with the claw in the order shown in the illustration.
      Fig 1: Identifying Blower Assembly Claw Tightening Sequence
      G05540745Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the blower assembly with the bolt and 3 screws.

      Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf) for bolt 

      Fig 2: Identifying Blower Assembly With Bolt And Screws
      G05540746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the 3 connectors.
  2. INSTALL AIR DUCT  (See INSTALLATION  )
  3. INSTALL ECM  (See INSTALLATION )
  4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY LOWER 
    1. Install the instrument panel sub-assembly lower (see INSTALLATION ).
  5. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER 
    1. Install the instrument panel sub-assembly upper (see INSTALLATION ).
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  7. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
  8. INSPECT SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
      Fig 3: Locating Connectors
      G05540734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals