LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Spec, Standard >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> 2AZ-FE Lubrication >> Oil Pump >> Installation

Oil Pump: Installation

  1. INSTALL OIL PUMP ASSEMBLY 
    1. Install a new gasket and the oil pump with the 3 bolts.

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

      2. Fig 1: Locating Oil Pump Assembly With Bolts
      G04975409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL OIL PUMP DRIVE GEAR 
  3. INSTALL NO. 2 CHAIN SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL CRANKSHAFT TIMING SPROCKET 
  5. INSTALL NO. 1 CHAIN VIBRATION DAMPER  (See INSTALLATION )
  6. INSTALL CHAIN SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL CHAIN TENSIONER SLIPPER  (See INSTALLATION )
  8. INSTALL TIMING CHAIN GUIDE  (See INSTALLATION )
  9. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE  (See INSTALLATION )
  10. INSTALL TIMING CHAIN COVER OIL SEAL  (See REPLACEMENT )
  11. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY  (See INSTALLATION )
  13. INSTALL CRANKSHAFT PULLEY  (See INSTALLATION )
  14. INSTALL CAMSHAFT TIMING GEAR ASSEMBLY  (See INSTALLATION )
  15. INSTALL OIL PAN SUB-ASSEMBLY  (See INSTALLATION )
  16. INSTALL CRANKSHAFT POSITION SENSOR  (See INSTALLATION )
  17. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY  (See INSTALLATION )
  18. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY  (See INSTALLATION )
  19. INSTALL IGNITION COIL ASSEMBLY  (See INSTALLATION )
  20. INSTALL ENGINE MOUNTING INSULATOR RH  (See INSTALLATION )
  21. INSTALL VANE PUMP ASSEMBLY 
  22. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  23. INSTALL FAN AND GENERATOR V BELT  (See INSTALLATION )
  24. INSTALL EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  25. ADD ENGINE OIL  (See REPLACEMENT  )
  26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  27. CHECK FOR ENGINE OIL LEAKS 
  28. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY  (See INSTALLATION )
  29. INSTALL FRONT FENDER APRON SEAL RH  (See INSTALLATION )
  30. INSTALL ENGINE UNDER COVER LH 
  31. INSTALL ENGINE UNDER COVER RH 
  32. INSTALL FRONT WHEEL RH  (See INSTALLATION )
  33. INSTALL HOOD SUB-ASSEMBLY  (See ADJUSTMENT )
  34. PERFORM INITIALIZATION 

    Perform initialization (see INITIALIZATION ).

    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals