LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> U241E Automatic Transaxle >> Valve Body Assembly >> Removal

Valve Body Assembly: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE ENGINE UNDER COVER LH 
  3. DRAIN AUTOMATIC TRANSAXLE FLUID 
    1. Remove the drain plug and gasket, and drain the ATF.
    2. Install a new gasket and the drain plug.

      Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

  4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY 
    1. Remove the 18 bolts, oil pan and gasket.
      NOTE: Some fluid will remain in the oil pan. Remove all of the oil pan bolts, and carefully remove the oil pan assembly. Discard the gasket.
      Fig 1: Identifying Gasket And Oil Pan With Bolts
      G05539390Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 magnets from the oil pan.
      Fig 2: Identifying Magnets Of Oil Pan
      G05539391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Examine the particles in the oil pan.
      Fig 3: Examining Particles In Oil Pan
      G05539392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Collect any steel chips with the removed magnets. Look at the chips and particles in the oil pan and on the magnets carefully to see the type of wear which might be found in the transaxle.

        Steel (magnetic): bearing, gear and plate wear 

        Brass (non-magnetic): bearing wear 

  5. DISCONNECT TRANSMISSION WIRE 
    1. Disconnect the 5 solenoid valve connectors.
      2. Fig 4: Identifying Shift Solenoid Valve Connectors
      G05539393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and lock plate, and separate the ATF temperature sensor.
  6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY 
    1. Remove the 3 bolts and oil strainer.
      NOTE: Be careful as some fluid will come out of the oil strainer.
      Fig 5: Identifying Oil Strainer
      G05388267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the oil strainer.
      Fig 6: Identifying O-Ring To Oil Strainer
      G05539395Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
    1. Support the valve body, and remove the 17 bolts and valve body.
      NOTE: Be careful not to drop the check ball body and spring.
      Fig 7: Identifying Bolts And Valve Body
      G05388272Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the check ball body and spring.
      Fig 8: Identifying Check Ball Body And Spring
      G05539397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 5 bolts, 3 plates and 5 shift solenoid valves.
      Fig 9: Identifying Bolts Plates And Shift Solenoid Valves
      G05539398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals