Transmission Wire: Installation

1. Coat a new O-ring and install it to the wire.
   Fig 1: Identifying O-Ring Of Transmission Wire Connector With ATF

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the wire with the bolt.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   Fig 2: Identifying O-ring With ATF Temperature Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
2. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

   Fig 3: Identifying ATF Temperature Sensor With Lock Plate And Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 5 solenoid valve connectors.

1. Install the 2 magnets in the oil pan.
Fig 4: Identifying Magnets In Oil Pan
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply seal packing or equivalent to the 18 bolts.

   Seal packing: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent 

   NOTE: Apply seal packing or equivalent to the bolts and tighten them within 10 minutes after application because the bolts should be seal bolts.
3. Install a new gasket and the oil pan to the transaxle case with the 18 bolts.

   Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

Fig 5: Identifying Transaxle Case With Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fluid type: Toyota Genuine ATF WS 

Standard capacity: 3.5 liters (3.7 US qts, 3.1 lmp. qts) 

1. Inspect the fluid (see ON-VEHICLE INSPECTION  ).

1. Perform initialization (see INITIALIZATION ).
   NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.