LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2008 >> tC Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> U241E Automatic Transaxle >> Park / Neutral Position Switch >> Installation

Park / Neutral Position Switch: Installation

  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Install the switch to the manual valve shaft.
      2. Fig 1: Identifying Switch To Manual Valve Shaft
      G05539369Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Temporarily install the 2 bolts.
    3. Place a new lock plate and tighten the nut.

      Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) 

      Fig 2: Identifying Lock Plate And Nut
      G05539370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Temporarily install the control shaft lever.
    5. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
      6. Fig 3: Identifying Lever Counterclockwise
      G05539371Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the control shaft lever.
    7. Align the groove with the neutral basic line.
      8. Fig 4: Identifying Groove With Neutral Basic Line
      G04975934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Hold the switch in position and tighten the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    9. Using a screwdriver, stake the nut with the lock plate.
      Fig 5: Identifying Nut With Lock Late
      G05539373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Install the control shaft lever, with the washer and nut.

      Torque: 13 N*m (132 kgf*cm, 10 ft.*lbf) 

      Fig 6: Identifying Control Shaft Lever, With Washer And Nut
      G05539374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    11. Connect the switch connector.
  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Install the control cable and clip to the control cable bracket with the clip.
      Fig 7: Identifying Transmission Control Cable Assembly
      G05539375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Temporarily install the control cable to the control shaft lever with the nut.
  3. INSTALL ENGINE UNDER COVER LH 
  4. ADJUST SHIFT LEVER POSITION 
    1. Adjust the shift lever position (see ADJUSTMENT  ).
  5. INSPECT SHIFT LEVER POSITION 
    1. Inspect the shift lever position (see ADJUSTMENT  ).
  6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Inspect the park/neutral position (see INSPECTION  ).
      Fig 8: Identifying Park/Neutral Position Switch Assembly
      G05539376Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  8. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals