Ignition Switch: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING COLUMN COVER
1. Remove the 2 screws and cover lower.
  HINT:
  
  Turn the steering wheel to the right and left as necessary to remove the 2 screws and cover lower.
  
  Fig 1: Identifying Steering Column Cover Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE IGNITION SWITCH ASSEMBLY
1. Disconnect the ignition switch connector.
2. Disconnect the unlock warning switch connector.
  
  Fig 2: Identifying Ignition And Unlock Warning Switch Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the cable tie.
  
  Fig 3: Identifying Cable Tie
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a small screwdriver, disconnect the claw fitting, and then remove the connector of the unlock warning switch.
5. Remove the 2 screws and ignition switch.
  
  Fig 4: Identifying Ignition Switch With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the screw and lock stopper.
  
  Fig 5: Identifying Lock Stopper With Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002