Rear Seat Inner Belt Assembly: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
1. Install the 3 anchor brackets with the 3 bolts.
  Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf)
2. Install the rear No. 1 floor board.
3. Install the No. 1 deck board.
4. Install the 2 rope hooks with the 2 bolts.
INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR COVER (See INSTALLATION )
INSTALL REAR SEAT INNER BELT ASSEMBLY RH
1. Install the inner belt with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not allow the anchor part to overlap onto the protruding part of the floor panel.
  
  Fig 1: Identifying Protruding Part And Bolt For Installing Rear Seat Inner Belt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SEAT OUTER BELT ASSEMBLY CENTER
1. Install the anchor part of the outer belt with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not allow the anchor part to overlap onto the protruding part of the inner belt RH.
  
  Fig 2: Identifying Protruding Part And Bolt For Installing Rear Seat Outer Belt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SEAT INNER BELT ASSEMBLY LH
1. Install the inner belt with the bolt.
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not allow the anchor part to overlap onto the protruding part of the floor panel.
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )
INSTALL DECK BOARD SUB-ASSEMBLY
INSTALL TONNEAU COVER ASSEMBLY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.