Ignition Switch: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING COLUMN COVER
1. Remove the 2 screws and cover lower.
  HINT:
  
  Turn the steering wheel to the right and left as necessary to remove the 2 screws and cover lower.
  
  Fig 1: Turning Steering Wheel To Right And Left
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE IGNITION SWITCH ASSEMBLY
1. Disconnect the ignition switch connector.
2. Disconnect the unlock warning switch connector.
  
  Fig 2: Locating Ignition Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the cable tie.
4. Using a small screwdriver, disconnect the claw fitting, and then remove the connector of the unlock warning switch.
  
  Fig 3: Locating Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 screws and ignition switch.
  
  Fig 4: Locating Ignition Switch Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the screw and lock stopper.
  
  Fig 5: Locating Screw And Lock Stopper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002