Ignition Switch: Installation

INSTALL IGNITION SWITCH ASSEMBLY
1. Install the lock stopper with the screw.
  
  Fig 1: Locating Lock Stopper With Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the ignition switch with the 2 screws.
  
  Fig 2: Locating Ignition Switch With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the claw position, and then install the connector of the unlock warning switch.
4. Install the cable tie.
  
  Fig 3: Locating Ignition Switch And Stopper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the unlock warning switch connector.
6. Connect the ignition switch connector.
  
  Fig 4: Locating Ignition Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER
1. Install the cover lower with the 2 screws.
  HINT:
  
  Turn the steering wheel to the right and left as necessary to install the 2 screws and cover lower.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 5: Turning Steering Wheel To Right And Left
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.