Charging (2AZ-FE): Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE FRONT FENDER APRON SEAL RH
1. Remove the 2 screws, 3 clips and apron seal.
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )

Fig 1: Locating Front Fender Apron Seal RH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE GENERATOR ASSEMBLY
1. Disconnect the generator connector.
2. Remove the terminal cap.
3. Remove the nut and disconnect the generator wire.
4. Remove the 2 wire harness clamps.
  
  Fig 2: Locating Generator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 bolts and generator.
  
  Fig 3: Locating Wire Harness Clamps And Terminal Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the bolt and wire harness clamp bracket.
  
  Fig 4: Locating Wire Harness Clamp Bracket And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002