Inspection Procedure
HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.
- CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2111 OR P2112)
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
- Read the DTCs.
Result
DTC RESULT REFERENCEDisplay (DTC Output) Proceed to P2111 or P2112 A P2111 or P2112 and other DTCs B HINT:
If any DTCs other than P2111 or P2112 are output, troubleshoot those DTCs first.
B: GO TO DTC CHART
A: GO TO NEXT STEP
- CHECK THROTTLE BODY (VISUALLY CHECK THROTTLE VALVE)
- Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.
OK:
Throttle valve is not contaminated with foreign objects and moves smoothly.
NG: REPLACE THROTTLE BODY
OK: GO TO NEXT STEP
- Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.
- CHECK DTC OUTPUT
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Clear the DTCs (See DTC CHECK / CLEAR ).
- Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
- Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
- Read the DTCs.
Result
DTC RESULT REFERENCEDisplay (DTC Output) Proceed to No +DTC A P2111 or P2112 B
B: REPLACE ECM
A: CHECK FOR INTERMITTENT PROBLEM