LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2007 >> tC Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2AZ-FE) >> SFI System >> DTC P2195 Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1); DTC P2196 Oxygen (A/F) Sensor Signal Stuck Rich (Bank 1 Sensor 1) >> Confirmation Driving Pattern

Confirmation Driving Pattern

Fig 1: Confirmation Driving Pattern
G04869187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the intelligent tester to the DLC3.
  2. Turn the ignition switch to the ON position.
  3. Turn the tester on.
  4. Clear the DTCs (See DTC CHECK / CLEAR  ).
  5. Switch the ECM from normal mode to check mode using the tester (See CHECK MODE PROCEDURE  ).
  6. Start the engine and warm it up for 2 minutes with all the accessories switched OFF.
  7. Drive the vehicle at between 38 to 75 mph (60 to 120 km/h) and at an engine speed of between 1,400 rpm and 3,200 rpm for 3 to 5 minutes.
    NOTE: If the conditions in this test are not strictly followed, no malfunction will be detected.
scientia non olet · About LEMON Manuals