DTC P2119 Throttle Actuator Control Throttle Body Range / Performance: Wiring Diagram

HINT:

Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119)

Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
On the tester, select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
Result

RESULT CHART

Display (DTC Output)	Proceed to
P2119	A
P2119 and other DTCs	B

HINT:

If any DTCs other than P2119 are output, troubleshoot those DTCs first.

B : GO TO DTC CHART

A : Go to next step

CHECK WHETHER DTC OUTPUT RECURS (DTC P2119)
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester ON.
4. Clear DTCs (see DTC CHECK / CLEAR ).
5. Allow the engine to idle for 15 seconds.
  CAUTION: Exercise extreme care and take precautions at steps (f) and (g) below. Failure to do so may result in the vehicle unexpectedly rolling away.
6. Securely apply the parking brake and move the gear selector lever to the D position.
7. While depressing the brake pedal securely, fully depress the accelerator pedal for 5 seconds.
8. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
9. Read DTCs.
  HINT:
  
  The voltage output of the throttle position sensor can be checked during step (g) using the intelligent tester. Variations in the voltage output indicate that the throttle actuator is in operation. To check the voltage output using the intelligent tester, enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / THROTTLE POS #1.
OK:

No DTC output.

NG : REPLACE THROTTLE BODY

OK : NORMAL