Rear Wheel Alignment: Inspection
- INSPECT TIRE (See INSPECTION )
- MEASURE VEHICLE HEIGHT (See
ADJUSTMENT
) NOTE: Before inspecting wheel alignment, adjust vehicle height to the specified value.
- INSPECT TOE-IN
Toe-in:
TOE-IN SPECIFICATIONToe-in
(total)A + B: 0°20' +/- 20' (0.33° +/- 0.33°)
C - D: 3.2 +/- 3.0 mm (0.13 +/- 0.12 in.)If the toe-in is not within the specified value, inspect and replace the suspension parts as necessary.
- INSPECT CAMBER
- Install the camber-caster-kingpin gage or position the vehicle on the wheel alignment tester.
- Inspect the camber.
Camber:
If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear and replace them as necessary because the camber is not adjustable.