Rear Wheel Alignment: Inspection

INSPECT TIRE (See INSPECTION )
MEASURE VEHICLE HEIGHT (See ADJUSTMENT )
NOTE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.

INSPECT TOE-IN

Toe-in:

TOE-IN SPECIFICATION

Toe-in (total)

A + B: 0°21' +/- 20' (0.35° +/- 0.33°)
C - D: 3.4 +/- 3.0 mm (0.13 +/- 0.12 in.)

If the toe-in is not within the specified value, inspect the suspension parts and replace them if necessary.

Fig 1: Identifying Toe-In

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT CAMBER

Install the camber-caster-kingpin gauge or position the vehicle on a wheel alignment tester.

Inspect the camber.

Camber:

CAMBER SPECIFICATION

Camber Right-left error

-0°57' +/- 45' (-0.95° +/- 0.75°) 30' (0.5°) or less

If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear, and replace them if necessary because the camber is not adjustable.