Symptom Confirmation And Diagnostic Trouble Code

HINT:

The diagnostic system in the SCION xB fulfills various functions.

• The first function is the Diagnostic Trouble Code (DTC) Check. In a DTC Check, a previous malfunction's DTC can be checked by a technician during troubleshooting. (A DTC is a code stored in the ECU memory whenever a malfunction in the signal circuits to the ECU occurs.)
• Another function is the Input Signal Check, which checks if the signals from various switches are sent to the ECU correctly. By using these check functions, the problem areas can be narrowed down and troubleshooting is more effective.

  Diagnostic functions are incorporated in the following systems in the SCION xB:

  SYSTEM DIAGNOSTIC TROUBLE CHART
  
  

  System	Diagnostic Trouble Code Check	Input Signal Check (Sensor Check)	Diagnostic Test Mode (Active Test)
  SFI System	X (with Check Mode)	X	X
  ABS with EBD & BA & TRAC & VSC System	X	X	X
  Electronically Controlled Automatic Transmission [ECT]	X (with Check Mode)	X	X
  Supplemental Restraint System	X
  Combination Meter	X		X

• In the DTC Check, it is very important to determine whether the problem indicated by the DTC is: 1) still occurring, or 2) occurred in the past but has since returned to normal. In addition, the DTC should be compared to the problem symptom to see if they are related. For this reason, DTCs should be checked before and after confirmation of symptoms (i.e., whether or not problem symptoms exist) to determine current conditions, as shown in the table below.

  Never skip the DTC Check. Failure to check DTCs may, depending on the case, result in unnecessary troubleshooting for systems operating normally or lead to repairs not pertinent to the problem. Follow the procedures listed above in the correct order.

• A flow chart showing how to proceed with troubleshooting using the DTC Check is shown below. Directions from the flow chart will indicate how to proceed either to DTC troubleshooting or to the troubleshooting of the problem symptoms table.

1. DTC CHECK 
2. MAKE A NOTE OF DTCS DISPLAYED AND THEN CLEAR THE MEMORY 
3. SYMPTOM CONFIRMATION 
   SYMPTOM CONFIRMATION
   
   

   X	Symptoms exist
   X	No symptoms exist

   1. A : Go to step   5 
   2. B : Go to next step. 
4. SIMULATION TEST USING THE SYMPTOM SIMULATION METHODS 
5. DTC CHECK 
   DTC CHECK
   
   

   X	DTC displayed
   X	No DTC displayed

   1. A : Troubleshooting of problem indicated by DTC 
   2. B : Go to next step. 
6. SYMPTOM CONFIRMATION 
   SYMPTOM CONFIRMATION
   
   

   X	No symptoms exist
   X	Symptoms exist

   If a DTC was displayed in the initial DTC check, it indicates that the trouble may have occurred in a wire harness or connector in that circuit in the past. Therefore, check the wire harness and connectors (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ).

   1. A : SYSTEM NORMAL 
   2. B : TROUBLESHOOTING OF EACH PROBLEM SYMPTOM 

   The problem is still occurring in a place other than the diagnostic circuit (the DTC displayed first is either for a past problem or a secondary problem).