LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2004 >> xA Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2425 (Engine Control System - DTCS P1148 To P2A03) >> DTC P1715 Input Speed Sensor (Primary Speed Sensor) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-III 

  1. If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Start engine.
  4. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

WITH GST 

Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About LEMON Manuals