How To Proceed With Troubleshooting

The hand-held tester can be used at step  3,  6,  9,  12.

1. Vehicle Brought to Workshop 
2. Customer Problem Analysis (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
3. Check and Clear DTCs and Freeze Frame Data (See  DTC CHECK/CLEAR   and  FREEZE FRAME DATA OF ABS  ) 
4. Problem Symptom Confirmation 
   1. Symptom does not occur: Go to step 5 
   2. Symptom occurs: Go to step   6 . 
5. Symptom Simulation (See  HOW TO PROCEED WITH TROUBLESHOOTING  ) 
6. DTC Check (See  DTC CHECK/CLEAR  ) 
   1. There is no output: Go to step 7 
   2. There is output: Go to step   8 
7. Problem Symptoms Table (See  PROBLEM SYMPTOMS TABLE  ) 
   1. Check for fluid leakage and Go to step   10 
8. DTC Chart (See  DIAGNOSTIC TROUBLE CODE CHART  ) 
9. Circuit Inspection (See  DTC C0200/31 RIGHT FRONT SPEED SENSOR CIRCUIT, DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT, DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR   to  TC TERMINAL CIRCUIT  ) 

   HINT:

   When 2 or more DTCs are recorded, and the problem is not identified, perform circuit inspection of the other DTCs.

10. Identification of Problem 
11. Repair 
12. Confirmation Test 
    1. End