Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
- Install the I/P dimmer switch to the I/P cluster bezel.
- Install the retaining screws to the I/P dimmer switch.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the I/P dimmer switch electrical connector.
- Install the retaining screw at the bottom of the I/P dimmer switch pad.
Tighten: Tighten the screw to 1.5 N.m (13 lb in).
- Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
- Install the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
NOTE:
Refer to Fastener Notice
.