LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2009 >> Vue Red Line, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Disc Brake System) >> Repair Instructions >> Front Brake Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing a new brake rotor, clean the friction surfaces of the brake rotor with denatured alcohol.
  2. Using the J 42450-A  , thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange. See Special Tools .
  3. Using the J 41013  , thoroughly clean any rust or corrosion from the mating surface of the rotor to the hub/axle flange. See Special Tools .
    4. NOTE: Refer to Fastener Notice .
    Fig 1: Brake Rotor Screw
    GM1873960Courtesy of GENERAL MOTORS CORP.
  4. Install the brake rotor.

    If installing the original brake rotor, align the rotor to the wheel hub as noted during removal.

  5. Install the brake rotor screw (1).

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

  6. After installing the brake rotor, measure the assembled lateral runout (LRO) of the brake rotor. Refer to Brake Rotor Assembled Lateral Runout Measurement .
  7. If the brake rotor assembled LRO measurement exceeds specification, bring the LRO to within specification. Refer to Brake Rotor Assembled Lateral Runout Correction .
    8. Fig 2: Brake Caliper Bracket Bolts
    GM1873958Courtesy of GENERAL MOTORS CORP.
  8. Position the brake caliper and bracket assembly to the vehicle.
  9. Install the brake caliper bracket bolts (1).

    Tighten:  Tighten the bolts to 185 N.m (136 lb ft).

  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals