Test Description
WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: Perform the Steering Position Sensor Test in order to verify if the steering wheel position sensor (SWPS) is operating properly.
- 4: Verify that the Lateral Accelerometer Input parameter is within the valid range.
- 5: Verify that the Yaw Rate Input parameter is within the valid range.
Vehicle Stability Enhancement System Inoperative
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Antilock Brake System Schematics | ||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
30 seconds | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | With the scan tool, perform the Steering Position Sensor Test. Did the steering wheel position sensor (SWPS) pass the test? |
- | Go to Step 4 | Go to Step 7 |
| 4 | With a scan tool, observe the Lateral Accelerometer Input parameter in the VSES data list. Does the scan tool display within the specified range? |
2.3-2.7 V | Go to Step 5 | Go to Step 8 |
| 5 | With a scan tool, observe the Yaw Rate Sensor Input parameter in the VSES data list. Does the scan tool display within the specified range? |
2.3-2.7 V | Go to Step 6 | Go to Step 8 |
| 6 | Replace the electronic brake control module (EBCM). Refer to Control Module References
in Computer/integrating Systems for replacement, setup and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 7 | Replace the SWPS. Did you complete the replacement? |
- | Go to Step 9 | - |
| 8 | Replace the yaw rate sensor/lateral accelerometer. Refer to Yaw Rate Sensor/Lateral Accelerometer Replacement . Did you complete the replacement? |
- | Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |