LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1632 (Antilock Brake System With Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0035-C0050 (without HP7) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Ignition ON, test for less than 1 V between the ignition voltage circuit terminal of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 12
    • Right front sensor circuit terminal 26
    • Left rear sensor circuit terminal 42
    • Right rear sensor circuit terminal 43
    • If greater than the specified range, test the ignition voltage circuit for a short to voltage.
  3. Test for less than 1 V between the signal circuit terminal of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 13
    • Right front sensor circuit terminal 27
    • Left rear sensor circuit terminal 41
    • Right rear sensor circuit terminal 44
    • If greater than the specified range, test the signal circuit for a short to voltage.
  4. Ignition OFF, test for infinite resistance between the ignition voltage terminal of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 12
    • Right front sensor circuit terminal 26
    • Left rear sensor circuit terminal 42
    • Right rear sensor circuit terminal 43
    • If less than the specified value, test the ignition voltage circuit for a short to ground.
  5. Test for infinite resistance between the following signal circuit terminals of the appropriate sensor listed below and ground.
    • Left front sensor circuit terminal 13
    • Right front sensor circuit terminal 27
    • Left rear sensor circuit terminal 41
    • Right rear sensor circuit terminal 44
    • If less than the specified value, test the signal circuit for a short to ground.
  6. Ignition OFF, disconnect the harness connector at the appropriate wheel speed sensor.
  7. Ignition OFF, test for less than 2 Ω between the appropriate ignition voltage circuit terminals listed below.
    • Left front sensor circuit terminal 12 at the EBCM harness connector and terminal A at the wheel speed sensor harness connector.
    • Right front sensor circuit terminal 26 at the EBCM harness connector and terminal A at the wheel speed sensor harness connector.
    • Left rear sensor circuit terminal 42 at the EBCM harness connector and terminal A at the wheel speed sensor harness connector.
    • Right rear sensor circuit terminal 43 at the EBCM harness connector and terminal A at the wheel speed sensor harness connector.
    • If greater than the specified value, test the ignition voltage circuit for an open or high resistance.
  8. Test for less than 2 Ω between the appropriate signal circuit terminals listed below.
    • Left front sensor circuit terminal 13 at the EBCM harness connector and terminal B at the wheel speed sensor harness connector.
    • Right front sensor circuit terminal 27 at the EBCM harness connector and terminal B at the wheel speed sensor harness connector.
    • Left rear sensor circuit terminal 41 at the EBCM harness connector and terminal B at the wheel speed sensor harness connector.
    • Right rear sensor circuit terminal 44 at the EBCM harness connector and terminal B at the wheel speed sensor harness connector.
    • If greater than the specified value, test the signal circuit for an open or high resistance.
  9. If all circuits test normal, replace the appropriate wheel speed sensor. If the DTC resets, replace the EBCM.
scientia non olet · About LEMON Manuals