LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1200 (Cruise Control System) >> Diagnostic Information and Procedures >> Cruise Control Inoperative/Malfunctioning >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Steering Wheel Controls Switch - Left

  1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  2. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
  3. Measure the resistance between the supply voltage circuit terminal 1 and the signal circuit terminal 3. Individually activate and hold each cruise control function switch and compare the resistance reading to the values for the On, Off, SET -, RES +, and Cancel switches.
    • If any of the resistance measurements for the On, Off, SET -, RES + and Cancel switches are not within the listed resistance values, replace the steering wheel controls - left.
Function Switch Minimum Resistance Value Maximum Resistance Value
Off O.L. O.L.
On 6.5k Ohms 7.1k Ohms
- SET 2.2k Ohms 2.4k Ohms
+ RES 3.7k Ohms 3.9k Ohms
Cancel 1.4k Ohms 1.6k Ohms