LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2009 >> Sky Base, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Battery Connections
    GM1593197Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable (2). Refer to Battery Negative Cable Disconnection and Connection .
  2. Open the positive battery cable connection cover.
  3. Loosen the positive battery cable bolt.
  4. Remove the positive battery cable (1).
    5. Fig 2: Identifying Positive Battery Cables & Cable Components
    GM1593202Courtesy of GENERAL MOTORS CORP.
  5. Remove the battery cable clip bolt (3).
  6. Remove the negative battery cable clips (4) from the wheelhouse liner.
  7. Remove the negative battery cable out through the engine wiring harness junction block bracket.
    8. Fig 3: Identifying Engine Harness Tie Straps & Cable Clips
    GM1592511Courtesy of GENERAL MOTORS CORP.
  8. Cut the engine harness tie straps (8).
  9. Remove the positive battery cable clip (7) from the bracket.
  10. Remove the positive cable clip (3) from the intake manifold.
  11. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  12. Remove the starter solenoid terminal nut (4).
  13. Remove the positive battery cable terminal (5) from the starter.
  14. Remove the positive battery cable clip (6) from the intake manifold.
  15. Lower the vehicle.
  16. Remove the positive battery cable.
scientia non olet · About LEMON Manuals