Installation Procedure
- Install the CIM.
- Connect and lock the wiring harness plug.
- Install the wiring harness holder.
Tighten: Tighten the 3 bolts to 3.5 N.m (32 lb in).
- Install the actuating lever.
- Engage the actuating lever.
- Install the rubber sleeve in the steering column paneling.
- Install the lower steering column paneling.
- Insert the ignition lock rosette.
Tighten: Tighten the 5 screws to 1 N.m (9 lb in).
- Install the rubber sleeve in the steering column paneling.
- Insert the ignition lock rosette.
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Connect the battery.
- For programming procedures, refer to Control Module References .
CAUTION:
Refer to Fastener Caution
.
NOTE:
When replacing the control unit, before removing, carry out a Reset using the Tech 2. Refer to Control Module References
.